Diving hose protector 80mm

RUbber hose protector for diving regulator hose or BC hose

To prevent dipped hoses such as pressure regulators or inflators from deteriorating at the crimping end, it is strongly recommended to use an elastomer protector

This flexible protection fits on the hose and pushes up to the base of the regulator side hose.

Tip: if the protections are too hard to put, a small passage in a basin of hot water will put them easily. The tool for installing the hose protectors is also very useful.

Length: 80mm

12mm passage diameter (must tighten on the hose)